SAS WOPRO WET

Mechanism of action

Universal organosilicon adhesive to enhance the biological effectiveness of plant protection products and fertilizers. It is used to improve wetting and increase the coating area of ​​the sprayed surface with the working solution due to the extreme reduction of the surface tension of aqueous solutions. Due to this, the pesticide is better retained on the surface of the plant, and is also better absorbed by the plant, thus increasing the effectiveness of the action on the plants weeds. In some cases, this can significantly reduce the consumption rate of the pesticide per unit of sown area.

Compatibility

Compatible with most pesticides. However, in each individual case, it is necessary to check the compatibility of the products. It is necessary to follow the regulations and recommendations for the use of all products in the mixture. Do not use with copper-based preparations or use only at a concentration of 0.01-0.02% if copper-based preparations were used in previous sprays.

It enhances the effectiveness of pesticides when used in tank mixtures.

The pesticide is better retained on the surface of the plant, and is also better absorbed by the plant, while the effect on weeds is enhanced.

Recommendations

Used in tank mixtures at concentration 0,025 – 0,1 % per hectare in accordance with the regulations for the use of pesticides, which uses a surfactant with.

Mode of application

The working solution is prepared immediately before treatment. The tank of the sprayer is filled with 1/3 of water, when the mixing device is switched off, add the necessary amount of the mother’s preparation diluted previously in a small amount of water. Then add water to the required amount in accordance with the regulations for the use of pesticides, which use the surfactant. The prepared working solution is poured into a pre-prepared amount of SAM Wopro Wet (per sprayer). Recommended pH of working solution in the range 5-8; use the working solution for 24 hours.